One piece center console for a C3 Corvette
I've been working on this down here in San Diego on my coffee table. It sat in my Vette for a few months till I had time to add a second layer and pull it out.
Made it out of polyester fleece, matte and resin, Bondo and spot putty. It provides a new home for my Mustang e-brake and my T56 short shifter. I'm running a Mustang e-brake because the stock cable location interferes with the yoke sticking out of my longer than stock T56 transmission. But the Mustang e-brakes pulley is off to the side, so it clears the yoke. |
Dyed the interior pieces black too. I've been taking them down here piece by piece fixing cracks and breaks. I'll post pics later.
|
Looks clean Adam.
|
Quote:
|
This is what I replaced. That was a piece of steel I cut for my T56 shifter and riveted to the stock console.
|
It looks great Adam. You sure you want to be a lawyer and not the next Foose?
|
Quote:
|
Quote:
Sorry, couldn't resist. |
Quote:
If I am very successful someday I would love to open up a 10 second Chevelle and a turbo LSX whatever producing shop. But till then no one is going to pay me enough money for a mortgage sitting on my driveway sanding Home Depot fiberglass and pondering cheap ways to install a T56. But thanks. :) :beer: |
Quote:
|
All times are GMT -7. The time now is 09:25 PM. |
Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.