Repaired stripped thread with JB weld.
Filled the hole, drilled it, tapped it (5/16). It works well, it is holding I'd guess 30ish ft lbs.
This was a stripped thread on the steering pin in my Berkeley jet. |
I'd go Heli-Coil usually, but I guess this would work at low torque. :huh:
|
Yeah heli coils are cool. But it's not a critically important bolt, so I didn't want to spend the $20.
|
All times are GMT -7. The time now is 09:38 PM. |
Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.