Flex Hone
 

Does anyone have a flex hone they want to lend me? :D

Before you hone it check to see what your piston to wall clearance is now. With the high silicon content in the SRP pistons you will probably want to go no more than .0050 but you should check with SRP. You don't want to make it too wide or the piston will rock and slap around in the cylinder.

You check it like this.

Ok, thanks. Now... hone me!

I don't have one.

I think I have one....will look for it today.

Got it ! I am Off Lake Forest and the 5fwy. I'll PM my #

Is that a 4" - 4 1/8" one?

Nope :suicide: just checked it.. 3.5 inch......might not work for your block.
.

Damn, well thanks for checking.

You're not going to check your piston to wall clearance, are you? You're just going to hone it and then bolt it back together.