Quote:
Originally Posted by enkeivette
So Im going to hone this little Honda engine with that 3 stone honing tool. But the stones look too rough for a final finish. Does anyone have an idea what grit cylinder walls are finished with? Im not buying a $50 flex hone to rebuild a $100 engine, ha.
|
I use the three stone all the time. They...at least mine, is not too rough. It doesn't take many turns to clean the walls....then after that it starts taking material from the walls...clearances will be a problem.
There are finer stones out there,,but I do not remember the number...getting old I guess.