New Walbro 450's ready to go in
Pulled out the old setup. There were no markings or part numbers on the pumps. They look just like Aeromotive 340's and i dont know if the marking got "washed" off by fuel. I'll post pics of the pumps tomorrow.
Squeezed the two Walbros in the bucket. The bottom already had an opening so that the strainers of the fuel pumps could stick out. I had to basically just had to open up the bottom of the bucket to fit the 450's.
Needless to say, we were able to squeeze them in and everything checked out and the car runs just fine. Next step will be to get back on the dyno, keep an eye on the fuel pressure and finalize the tune. Then I can start on that fuel return setup.