Thread
:
03/04 Cobra motor in a Bronco
View Single Post
01-13-2010, 10:21 PM
#
9
SeanPlunk
Resident Avatar Gambler
Join Date: Nov 2006
Posts: 5,997
Tweet
Quote:
Originally Posted by
houseofdiesel
Well took the charger off and sent her out to Steg's to get ported and cut out the rear section to start welding in saddles while waiting for the outer knuckles and steering components. The front crossmember is going to tie into the Steering box plate so I have to wait for that stuff before I start drilling and cutting. Oh well there is plenty of plating to do in the new sections and the rest of the parts should be here tomorrow anyways.
The inside of the motor looks like things have been holding up just fine but for some reason all of the intake plenum bolts on the driver side rail were sheared and the passengers were bent. Luckily no damage on the inside though. Oh well here are some pics of the progress.
Update.
__________________
Insanity: doing the same thing over and over again and expecting different results.
SeanPlunk
View Public Profile
Send a private message to SeanPlunk
Find More Posts by SeanPlunk