I got the trans cross member done tonight but I hope it will work. Joe, can you tell me if this is how the trans lines up with the shifter hole on your Mustang? I bolted the engine and trans together and set them in the car then tried to line them up using the SBC/T5 cross members as a guide. I set the engine as far back as I could so hopefully it will all work well.
This is a picture looking down through the shifter hole in the floor.
Rear view of the cross member.
Another angle.
Passenger side of cross member.
Drivers side.
Tailshaft looking up.
Drivers side of trans.
Drivers side of engine.
Passenger side of engine.